Technical Knowledge
News, activities and updates from BILOCO.
Pumps and Piping: Preparing for Testing & Commissioning
Pump and piping commissioning should be planned when the work scope is set, not postponed until handover. Isolation, measurement, venting and test records must be accommodated by the installation.
Read article →
Factory Plumbing and Drainage: Interfaces That Are Easy to Miss
Factory plumbing and drainage support process needs, sanitation and utility systems. Connection points and gravity-drain levels are frequent sources of discrepancy between design assumptions and site conditions.
Read article →
Industrial Switchboards: Installation and Handover Checks
Industrial switchboards connect electrical design, equipment selection and ongoing operation. Inspection should cover configuration, working clearances, circuit identification, protection, earthing and relevant test records.
Read article →
Smoke Exhaust and Pressurization: Why Early M&E Coordination Matters
Smoke extraction and stairwell pressurisation are tied to the building fire-safety strategy. Design criteria, served zones, equipment positions and fire-alarm control interfaces must be coordinated as a single system.
Read article →
Five Checks Before Industrial Electrical Installation Starts
Before industrial electrical installation, supply diagrams and connected loads must be checked against the floor plan, switchboard locations and other services. Early discrepancies can affect cable routes, terminations and ou.
Read article →
HVAC Ductwork: Coordination Issues That Commonly Cause Rework
Ductwork affects ceiling clearances, maintenance access, diffuser placement and architectural integration. Late coordination may force route changes after structure, lighting or fire-protection services are installed.
Read article →